Baron Richard
11-04-2007, 12:30 PM
Is there a way to cut and make a tool path out of an outline? I have a PNG pattern file I have imported that is a rather complicated set of curves and I want to cut a 1/8"x1/2" deep line around one side of the pattern on 1 1/2" stock that I can finish with a jig saw and flush cutting router bit. The Outline command does an excellent job of finding the outline all the way around, but I'd like to clip it at 2 points and turn it into a tool path. Trying to use the spline tool is proving more than a little tedious and more of a "eyeball best fit" rather than a nice edge.
If not, this definitely needs to go in the list of future improvements.
Thanks
If not, this definitely needs to go in the list of future improvements.
Thanks