Stuck in Accessory Menu

[Lucky13]

I just got my machine back from Taxas today, I went to start a project, I turned the machine on and the accessory menu comes up and I can't get out of it. I tried re-programming the memory card and I get the same error. Can anyone help?

[Digitalwoodshop]

You need to follow the link they gave you to upgrade to 1.121 via the download. Then follow the instructions to select "Cover" for your new Probe connection point vice the Z connection jack.

If you need help look at post started by me for "1.121 is out Flash Traffic"

Your unit has the New Z Bundle with the 14 pin cable.

If you own a probe you need the adapter cable too from LHR.

AL

http://www.carvewright.com/forum/showthread.php?p=34348#post34348

[Lucky13]

OK, I recevied 1.21 today but I can't upload it to my card. I beleive I use to get a prompt on the Flash Manager to update firmware. I no longer get this prompt so how or where do I go to upload the new firmware. Once again I thank eveyone on this forum for their continued help.

Thanks,
lucky13