View Full Version : Depth Limit to Carve Region
docmjn
10-22-2007, 03:02 PM
Is there a depth limit to carving a region?
Every time I try to carve a region deeper than 0.5 in, I get axis stalls.
Thanks,
docmjn
Jeff_Birt
10-22-2007, 03:13 PM
1" is the advertised max depth of cut, at it will actually do a bit more than that. I assume you are using the standard carving bit?
docmjn
10-22-2007, 03:20 PM
I am using the standard carving bit. Is there a better one to use?
Thanks,
docmjn
Jeff_Birt
10-22-2007, 03:30 PM
Nope, that should work just fine. Does it give you an error on every project over 1/2" or just one in particular?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.