wiring

[dragoncarver]

i had some wiring catch in the back roller this pulled a connection loose i got the connection back together but their is a yellow wire that is still not connected with several places it may go. the question is: does anyone have a wiring scematic or know where this wire should connect at? i was getting an error message "insert board (back)" before i pluged the connection back in and since have not turned the machine back on

[Digitalwoodshop]

Based on the message it must be the wires to the roller switch... It looks for a compressed roller with the head cranked down and if it does not see the roller switch it thinks that no board is installed.

Use the Option menu to call up the sensor data and both roller switches are listed. Compressed or Un compressed. Be careful not to short the wire to the case metal as it could burn out the computer interface. Do the wire playing with the power unplugged.

Good Luck,

AL

[dragoncarver]

thru the process of ilimination i got it actually got it on 1st try:o