Mystery Part

[gtj44]

Can anyone help identify this part. I was vacuuming up after a carve and heard someting hard rattle down the vac hose. I pulled the cover off the vac and found this part laying on the dust. I had the hose tool right over the cut motor when this happened. I ran another project with no ill effects. It's about 1" long and 3/8" high. Thanks

[Digitalwoodshop]

Survey Said.... Brass Roller O ring.

AL

[gtj44]

Thanks for the reply, but this a injection molded hard plastic piece.

[Digitalwoodshop]

Survey said.... The little piece of plastic that is part of the vent system on the underside of the left side of the lid near the keypad side of the machine. When you remove the top and re install it you must watch the position.

If this was Cash Cab I would have 1 strike....


Was that it?

AL