DustyUsr
08-25-2007, 08:31 AM
All Concerned,
when you get your new Bit Sets from CW, you need to check everyone to make sure that they have Thread Lock on the set screws.
I was cutting a Name Plate with the 90 Bevel Bit when one of the blades broke off, I shut the machine down and the Bit fell out of the Adapter.
I e-mailed CW this morning about this problem.
Before you ask, I was cutting Red Cedar.
So Please before you mess up a Good Peice of work, make sure your bits are secure in the Adapter.
Have a Great day all and
Thanks for all of your support.
Michael
when you get your new Bit Sets from CW, you need to check everyone to make sure that they have Thread Lock on the set screws.
I was cutting a Name Plate with the 90 Bevel Bit when one of the blades broke off, I shut the machine down and the Bit fell out of the Adapter.
I e-mailed CW this morning about this problem.
Before you ask, I was cutting Red Cedar.
So Please before you mess up a Good Peice of work, make sure your bits are secure in the Adapter.
Have a Great day all and
Thanks for all of your support.
Michael