Door Panels

[Keenosan]

Someone earlier was asking if the machine would do door panels like the 3D Router Creator. I made this using only the arc tool, selected the 90 V-Groove bit and then selected a depth profile. You only have to do the upper 1/4 of the pattern, then mirror vertically, then horizontally, then diagonally. It doesn't look exactly like the 3D Router Creator version, but it looks pleasing nevertheless.

[Keenosan]

This is a picture of the panel. I haven't cut it yet.

[Dan-Woodman]

Way too cool.
That even looks better than the 3-D router creator, and with the CW it will be so much easier.

[Keenosan]

Here's a rosette made the same way using different depth profiles.

[Keenosan]

Oops. Here's the picture.