Lin
07-21-2007, 09:43 AM
The new machine has arrived. I have lubed the flex cable and will take another shot at the eagle carving that I only got 44% done on. I do have a question. I was running the board "stay under rollers" and centered. The board is 7"+ longer than the designed project. Can I put the same board back into this new machine and recut it? I cannot for the life of me remember where the bit touches off to set the board thickness...so..I don't know if it will try to touch off on an area that is already carved. Can this be done and do I have to bypass something to do it?...If it touches off on a carved area how do I stop and abort the project?
I really had no idea what to put into search on this to find an answer. I do remember others that have recut their project but didn't know if there is something I need to know or do to do this without issue.
Lin
PS. I realized after sending the message that I had invertently put inches next to 1/2 in the header...should not have been there. The board I'm asking aout is 3/4" thick. Could not modify the header to read correctly.
I really had no idea what to put into search on this to find an answer. I do remember others that have recut their project but didn't know if there is something I need to know or do to do this without issue.
Lin
PS. I realized after sending the message that I had invertently put inches next to 1/2 in the header...should not have been there. The board I'm asking aout is 3/4" thick. Could not modify the header to read correctly.