Sanding

[Paul Wheeler]

Call me lazy but has anyone though of asking if Carvewright could come up with a bit for sanding a project. Here is what I’m thinking with a few tweaks to the firmware the machine should be able to carve your project and then ask for a sanding bit and follow the same path and do the finish work for you. It may be an over simplification but it seams possible.

Paul

[pkunk]

OK, YOU'RE LAZY! :p:)

[Lucky13]

OK, I'm lazy too.

[Dan-Woodman]

I've had good luck with the wire brush wheel that goes in the Dremal

[liquidguitars]

I have a few parts that could use a small sanding disk hmmm..
:rolleyes:

LG