Dirtydan
06-15-2007, 05:46 PM
I'm in the process of doing scan and all of a sudden everything stops. "Check Probe" is displayed. So I remove the plug and re-install it. Same problem. Removed the entire probe and then re-installed it nothing the first time. The second time it worked for about 2 seconds. After about 20 unplugs and plugins it took off again for about 5 seconds.
While the error code was still there and the probe plugged in, I moved the probe with my finger... Bingo. it's working again..., well for about a minute or so... Wiggled the probe again and it's off and running once again. It's now at 22% and has about an hour left on the scan...
Any ideas? Has any one had this problem before or is it just me?:mad:
While the error code was still there and the probe plugged in, I moved the probe with my finger... Bingo. it's working again..., well for about a minute or so... Wiggled the probe again and it's off and running once again. It's now at 22% and has about an hour left on the scan...
Any ideas? Has any one had this problem before or is it just me?:mad: