ljdm
06-04-2007, 06:16 PM
Just trying to be clear on this - I tried the 1/4" tubing to lube the shaft, let it soak overnight, took it out today to let it drip. Question is, is there any concern that oil trapped in the inside of the cable will spin out and make its way into the bearings of the cutting head? I'm assuming it isn't sealed between the end of the shaft and the inside of the cutting head? I thought I recalled reading a post asking about oil inside the shaft, din't know the answer to the question. Or is letting it hang for a few hours and wiping it dry enough?