PDA

View Full Version : Camper trailer sign


jspringertx
05-15-2007, 06:32 PM
I carved this sign using a piece of 12" X 19" whiteboard. I was pleased at the results. Note the Lone Star Quarter in the center of the sign.
RC Woodworks
05-15-2007, 08:14 PM
Very nice, I have problems with raised western. It is always too shallow, even if I set the height at 999.

Nice job
HillBilly
05-16-2007, 01:32 AM
I absolutely love it. Could we maybe make it our new "motto" ?

"Springer" Carvers from them that might have had a vision, but somehow became sidetracked along the the way...<grin>
oldjoe
05-16-2007, 11:41 AM
Very nice about how long did it take to carve
jspringertx
05-16-2007, 08:34 PM
On best quality 1 hr 21 minutes. If I could just get the CompuCarve to paint the letters I would have it made.

By the way, I used the new cordless Dremel tool to clean up some spots. It fits in your hand perfectly and is easy to control. It sits in its own charger when not in use. I have been able to control it much better than the electrical model.