View Full Version : box around imported pattern
Dunkin
05-11-2007, 08:15 PM
I import a graphic from paint shop pro... and when adding the pattern to a project... it adds a square box around the graphic... how do I get rid of that square box?
Mikewiz
05-11-2007, 08:22 PM
after the crop section in designer when it shows you the carving, you will see a box checked that states floor edges. uncheck that box and that should remove your problem.
Dunkin
05-11-2007, 08:56 PM
after the crop section in designer when it shows you the carving, you will see a box checked that states floor edges. uncheck that box and that should remove your problem.
Much thanks Mike :)
Worked like a charm!
pastime106
05-11-2007, 10:03 PM
I have had the same problem with images I imported, then figured the "un-checking" of the floor edge box. (Thanks to past posts) the problem that I am having is that I can not seem to figure out how to do it on an item that I had scanned. (No floor edge box to un-check)
I also noticed that the floor edge is not on all of my scans just some. Something to do with setting my depth for the scan perhaps. I have searched all over the board and could not seem to find the answer. Any help would be appreciated.
Thanks
Tom
pkunk
05-11-2007, 10:23 PM
Wow, I'm lost. Where is the 'floor edge' box?:confused:
HillBilly
05-11-2007, 11:13 PM
I my self usually just use my photo editing programs to "crop" the image to only leave what I wish to be seen before importing the image.
VtBlues
05-12-2007, 02:42 AM
When you are importing am image file, on the screen where you can raise, lower or invert the image, the "Floor edge" box is in the lower left corner.
pkunk : Wow, I'm lost. Where is the 'floor edge' box?
Pic. of floor edge
JOHNB
05-12-2007, 10:31 AM
What Does "floor Edge " Do??
liquidguitars
05-12-2007, 12:23 PM
Pic. of floor edge
looks like someone is dressing up and knocking down doors.. You guys sure know how to party! ;) :rolleyes:
LG
You know some of these questions and answers are just asking for a Wise
A__! answer!!
DDV
pastime106
05-13-2007, 12:31 PM
As far as I can tell the floor edge just defines the lowest portion of the item imported. A uniform depth, and sets it for a machine starting point. I have not found a real use for it, there probably is one, but I have not figured out why. I searched and did find the floor edge, just not how to remove it on scan.
pastime106
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.