kyeakel
05-10-2007, 10:24 AM
I scanned an object, which worked perfectly. However, I set one of the corners at the wrong location and the scan stopped short of scanning the entire object.
If I scan the remaining section, can I splice it on to the portion already scanned?
Is there a way to tell the carvewright to add the section to an already completed scan? I haven't removed the piece and the probe sits right were it left off.
Is there a way to seam two scans together in the carvewright editor?
It took a few hours to scan this, and I didn't want to rescan the whole thing.
Thanks
If I scan the remaining section, can I splice it on to the portion already scanned?
Is there a way to tell the carvewright to add the section to an already completed scan? I haven't removed the piece and the probe sits right were it left off.
Is there a way to seam two scans together in the carvewright editor?
It took a few hours to scan this, and I didn't want to rescan the whole thing.
Thanks