View Full Version : Up-Down mechanism jammed!
Signmaker
05-04-2007, 10:12 AM
My roller mechanism is jammed in the up position. I didn't do anything funky.
Board is 3/4" thick.
:-x
What do I do???
Thanks,
Signmaker
Go here to see the solution:
http://www.carvewright.com/forum/showthread.php?t=2852
jimmars
05-04-2007, 10:38 AM
Chances are you just cranked the mechanism up too far. The fix is detailed in page 40 of your manual under Vertical Lockup.
Signmaker
05-04-2007, 12:01 PM
Yes, there it was. That red handle staring back at me saying "Shouldn't you release me first?"
BTW, info on vertical lockup, if it happens, is on page 37. Ck the red thing first!
Thanks for the replies...
Signmaker
rjustice
05-04-2007, 01:02 PM
LOL... is it on the same page that asks you if it is plugged in ?
:D :D
Just kidding !
Happy carving,
Ron
Gman_Ind
05-04-2007, 01:03 PM
Never overlook the obvious, 'cause its the easiest to overlook.
rjustice
05-04-2007, 01:07 PM
Mike,
We quit putting large warning notes on our engineering drawings, because it was a sure sign someone would overlook it. (I am not kidding)... we had to go to highlighting the text with pink instead...LOL
Go figure...
Ron
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.