eagle1
05-01-2007, 10:57 AM
Here is the fish hook pattern That I used to make the Eagle Claw boards.
1) One pattern has a carved region (for the hole in the hook) on it. Due to the size of the pattern, I was unable to cut the fish hook body out, then the hole, too much vibration. (fish hook.ptn) When complete just remove the wood from the hole carve.
2. The next set for the fish hook is two patterns:
1st carve the hole (fish hook hole.ptn)
2nd carve the body (fish hook body.ptn)
Doing it this way removes the wood from the hole, but be careful, due to the size of the cut, the wood will come out of the hole just as it is finishing the cut.... when the hole is finished cutting, you will have to remove the wood from the project..... you don't want to break a bit or something.
1) One pattern has a carved region (for the hole in the hook) on it. Due to the size of the pattern, I was unable to cut the fish hook body out, then the hole, too much vibration. (fish hook.ptn) When complete just remove the wood from the hole carve.
2. The next set for the fish hook is two patterns:
1st carve the hole (fish hook hole.ptn)
2nd carve the body (fish hook body.ptn)
Doing it this way removes the wood from the hole, but be careful, due to the size of the cut, the wood will come out of the hole just as it is finishing the cut.... when the hole is finished cutting, you will have to remove the wood from the project..... you don't want to break a bit or something.