View Full Version : OMG, Going to jinx myself
Skippy
04-27-2007, 05:26 PM
2nd machine. Haved owned one since Jan 07. Returned to Sears at the suggestion of Tech Support. Got new machine at end of March. Had to replace the controller and then the flash card on the new machine.
IT CARVED TODAY.
Got though the whole project with no faults.
The job came out so-so on MDF but I actually got though a whole carve.
Whoooopie.
Flip
Skippy
04-28-2007, 06:35 PM
Just got through 2 more carvings with no errors. Front qnd back as 2 seperate projects.
Quick project for the Grandkids for a present for their Mom on Mothers day.
All went fine with no faults.:D
However I now have a question??
When I check my usage meter i get:
Cut motor on time = 0.00
Total power on time = 0.00
Servoing time = 0.00
Scanning time = 0.00
The total time for the 3 projects I have done is about 2 hours and 40 minutes when I loaded them to the flash card.
Does this mean I have unlimited hours for my 1 year warrenty from?:rolleyes:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.