Ted Grinnell
04-15-2007, 03:17 AM
The Rollers In My Machine Had A 1/4" Difference In Them When The Left(controler) Side Would Touch The Board And The Right Would Still Lack 1/4" Of Touching.
I Confirmed That The Sides Were Misalligned By Cranking The Carriage Up So That The Left Side Was 1" From The Top Of The Slider Shaft, And Measured The Right Side. To Adjust Leave The Carriage At This Place Until Adjusted.
I Removed The Top And The Right (opposite The Keypad) Side. There Are Two Small Screws That Will Have To Be Removed From The Inside Of The Machine. You Then Can See The Screw That Raises And Lowers That Side. Where The Screw Goes Through The Carriage There Is A Threaded Nut And A Jam Nut. The Nuts Are About 1 1/8" Or So Each. You Will Have To Loosen The Jam Nut. Once Loosened Start Turning The Threaded Nut And That Side Of The Carrier Will Move Independent Of The Left Side. When Both Are The Same, Tighten The Jam Nut. Reassemble And Test By Cranking Up And Down.
I Confirmed That The Sides Were Misalligned By Cranking The Carriage Up So That The Left Side Was 1" From The Top Of The Slider Shaft, And Measured The Right Side. To Adjust Leave The Carriage At This Place Until Adjusted.
I Removed The Top And The Right (opposite The Keypad) Side. There Are Two Small Screws That Will Have To Be Removed From The Inside Of The Machine. You Then Can See The Screw That Raises And Lowers That Side. Where The Screw Goes Through The Carriage There Is A Threaded Nut And A Jam Nut. The Nuts Are About 1 1/8" Or So Each. You Will Have To Loosen The Jam Nut. Once Loosened Start Turning The Threaded Nut And That Side Of The Carrier Will Move Independent Of The Left Side. When Both Are The Same, Tighten The Jam Nut. Reassemble And Test By Cranking Up And Down.