Replaced my truck bearings, now get Y axis stall E05-0314

[Ranfy]

What did I do wrong? I started a simple test project, it carved a couple of letters and then I got 'Check cut motor'. I hit Enter and then I got Y Axis Stall Err E05-0314.

[Mugsowner]

When you say the truck bearings, I assume you are talking about the Z axis, not the bearings on the Y axis. Make sure rails are clean. Make sure the Y axis rollers(bearings) are turning. Check the Y drive belt for wear. Make sure belt is tight. There is a encoder on the back of the Y axis motor that may have dust in it, this normally does not cause stall issues. i am heading out for the weekend, so I hope this helps.

[want2b]

After getting the Check cut motor did you notice where the bit was? If the bit was down on the wood the stall may have been caused by it not cutting and dragging on the wood. Unfortunately you'll have to restart the project. Try restarting it an see if you get the Check cut motor before any cutting starts to be sure where your problem is. May be brushes, they wear out at inconvenient times.