robboz4
08-22-2020, 05:00 PM
I was using an old pattern from October 2012 - Heart shape box. I have made this before with out problems and wanted to make another for my Granddaughter. The only addition to original plan was to add her initials. The first carved OK and I flipped over the board and started the second side to carve. I thought there as a problem as the carving bit seems to carved though. But as this entire part is cut out I couldn't remember how it carved. The issue is that the first carve did not start in middle of the board like I assumed I asked it to. The second side did carve from the center. There ware no errors on the carve or power fluctuations during the carve. So I assume I goofed on the first side carve.
Is my assumption correct?
The front and rear patterns are centered both horizontally and vertically, and I printed it fine many years ago... as far as i can remember anyway and the evidence is on the dressing table!
A couple of pictures might explain it better.8848188482
Like I said I think I goofed but just was checking with the forum as it's been a while since I used the machine.
Is my assumption correct?
The front and rear patterns are centered both horizontally and vertically, and I printed it fine many years ago... as far as i can remember anyway and the evidence is on the dressing table!
A couple of pictures might explain it better.8848188482
Like I said I think I goofed but just was checking with the forum as it's been a while since I used the machine.