Thanks to......

[rnichols]

dbenus and bergerud for their help. Not completly finished yet but getting there. My first question is what would cause the step-up? I went ahead and used it with the ridge on the bottom. again thanks.
8837188372

[dbemus]

rnichols

I believe the step up is a fault in the layout of the mpc, I will go back and check and make the correction if necessary. I think I did not set the edges to "0". Glad to see your finished project. I plan to carve it but my dust collection still down.

dbemus

[dbemus]

rnichols,

I think the step up resulted because on the mpc, I did not turn the floor feather and feather off on each region. Picked that up by reviewing one of the tutorials on the CarveWright site.

https://www.youtube.com/watch?time_continue=8&v=L3Hv52VRJsE&feature=emb_logo

[rnichols]

I very rarely use feather so I'm surprise I did not check it. Still it turn out great and accomplish what I wanted. I too have watch that video in the past but again I did not think of it. The couple of problems that happen were both my mistakes so I can not complained but use them as a learning experience.

[oscarl48]

Great looking project. Love the memories that the patches brought back. I started my career in TAC but ended in AFGSC which is what SAC evolved to in the modern world.

[bergerud]

I do not think it was the feather. It appears to be a change in depth. My guess would be that something physically moved during the carve.

[rnichols]

Still trying to decide if I want my color patches or stay with the OD. :rolleyes: