Had an error when I flipped my board

[Loriblackdog]

Hi All,

I was in the middle of a carve, the back side completed, I was flipping the project board went to lower had error message front roller error, so i had to figure out what to do, finally got the error cleared, went to put project board to where I left off, however it is making me start all over? Isn't there a way I can get back to the side that I need to carve? I am really trying to learn this, getting a little better bur still need help. Thanks you in advance for any help you can send my way.

Thank you
Loriblackdog

[lynnfrwd]

As instructed over the phone, remove the back of the project from your .mpc file and re-upload the front only with a new name for the project.

[Loriblackdog]

Thank you so much, and I have made note of this so it won't happen again.:p

[CarverJerry]

If you have a 2 sided carve it will always cut the back side first. Just something to keep in mind Lori.