View Full Version : Carvewright needs a new arm...
I couldn't get the machine to do a carving on a 11inchx6 foot board because it always wanted to start the carving near the wrong end of the board. I finally realized I set the end of the carving at 3 1/2 from the finish end of x axis. The machine needs an arm to reach out and slap someone who does what I did. I think it would be a big help to stop people doing stupid stuff?
Jeff_Birt
04-02-2007, 08:54 PM
Good one Gary :D
If I strap my arm down and run some dye down the cutter, would that be a good tattoo, or would the blood letting be too much? Just wondering.
Sarge
04-02-2007, 11:09 PM
That makes you on an even playing field with about everyone here!!!! :D :p :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.