Digitalwoodshop
02-06-2019, 08:12 PM
I found an interesting video of the troubleshooting of a power supply very similar to the CW. This power supply runs on 220 Volts AC because of his country location.
He stresses that working on this power supply can be very dangerous as is OUR power supply running on line voltage of 115 volts AC.
We have seen LHR has moved to an enclosed power supply for a much safer machine.
Primarily we have only seen the L2 Coil snap off and if you look close to his schematic and the picture I posted you can see the L2 Coil in the circuit upper edge on the 5 volt line.
This is just for the curious about how power supplies work.
AL
https://www.youtube.com/watch?v=hHMDFwgQnqk
He stresses that working on this power supply can be very dangerous as is OUR power supply running on line voltage of 115 volts AC.
We have seen LHR has moved to an enclosed power supply for a much safer machine.
Primarily we have only seen the L2 Coil snap off and if you look close to his schematic and the picture I posted you can see the L2 Coil in the circuit upper edge on the 5 volt line.
This is just for the curious about how power supplies work.
AL
https://www.youtube.com/watch?v=hHMDFwgQnqk