Need help designing a pattern

[JDPratt]

I need a little help designing a pattern. If anyone wants to jump in and design this for a carvewright it would be much appreciated and I will gladly compensate the designer. I want to carve this carving board at 24"x14" (I would go bigger if the machine allowed it. I don't want to do it in two carves). Thanks in advance.

John

[oscarl48]

Here is my version. After figuring out the technique to use it turned out to be a quick build.

[bergerud]

Here is an attempt made in Designer. Original mpc and pattern.

[oscarl48]

Dan, that is super clean. Awesome design.

[bergerud]

Thanks Oscar. I thought I might carve it but, my wife now says she does not like wooden cutting boards! Oh well it, it is always fun to play in Designer. Maybe John can use it.

[SteveNelson46]

Here's my stab at it. I modeled it from scratch but I didn't use the Designer.

MPC is too large for the website. Here is a link to download it and the pattern.

EDIT: Project edited for slightly smaller board.


(https://drive.google.com/file/d/1NZ9DBvaQMGUWWAY4NfkySIU7AeyNMyjp/view?usp=sharing)https://drive.google.com/file/d/1kTo_k4__5zCo8QpSPpOpL6RJw4_U_Ym3/view?usp=sharing
(https://drive.google.com/file/d/1kTo_k4__5zCo8QpSPpOpL6RJw4_U_Ym3/view?usp=sharing)
https://drive.google.com/file/d/1Xs-FrD-D1v0BoWkQ-8YsKPVZAhguZdxP/view?usp=sharing

[oscarl48]

Steve, Very nice. lol. Mine is the ugly duckling compared to you'alls.

[SteveNelson46]

Steve, Very nice. lol. Mine is the ugly duckling compared to you'alls.

I thought your idea of a single wedge shaped drain channel at the bottom looked better so I changed mine.

[JDPratt]

Here's my stab at it. I modeled it from scratch but I didn't use the Designer.

MPC is too large for the website. Here is a link to download it and the pattern.



That came out awesome. I appreciate the quick responses and designs from everyone. I'm going to give Steve's a carve and see how it comes out.

Steve, PM me and I will send you some compensation for your efforts. It is much appreciated

[SteveNelson46]

That came out awesome. I appreciate the quick responses and designs from everyone. I'm going to give Steve's a carve and see how it comes out.

Steve, PM me and I will send you some compensation for your efforts. It is much appreciated

Compensation isn't necessary. It was fun and I'm glad I can help. With that said, no guarantees. I haven't carved it.

EDIT: In retrospect, you may have to reduce the board and the pattern size. I don't think a 15" board will fit in the machine. Be sure you leave at least 1/2" on each side for the rollers.

This one has been edited for a 14.5" board.

https://drive.google.com/file/d/1Xs-FrD-D1v0BoWkQ-8YsKPVZAhguZdxP/view?usp=sharing

[JDPratt]

I will and thank you again for your help on this project. to be honest I was going to try to carve the one posted by Dan, but I don't have sweeper and it required that for me to carve or make any changes.