Rotate

[cjudas]

I'm working on a couple name signs for a friends horse's stalls. I drew up a pair of horseshoes a pair of stirrups for a bit of decoration. I really want these to be angled 45* or 33.5* but can't figure out how to change them, short of starting all over. I know they aren't the greatest but I hope they carve OK. Any help is greatly appreciated.

Thanks
Chris

8678186779

[fwharris]

Unfortunately you can not rotate vectors. You might try grouping each of them and making them a pattern so then you could rotate them.

[cjudas]

OK Thanks.... I know stupid question but...How do I change them to patterns?

[fwharris]

Read through this to find out how.. http://www.carvewright.com/assets/service/Learning_Lab/DesignProject7-12.pdf

[myshop1044]

Hi cjudas if you need the horse shoes pattern I have the exact match, let me know

[cjudas]

Yes if you would. That would be great sir. Thank you very much

[myshop1044]

Ok I will attach them later on this morning

[myshop1044]

try these 3.1 version hope they work for you
Perry B.

[cjudas]

I only have 2.007, I can't open it.

[myshop1044]

version 187 give it a try

[cjudas]

I think I can make those work. Thank you very much sir.

[myshop1044]

I have hundreds of pattern, drop me a line when you are in need