picking carving problem

[joepei]

When i go to the carving choice and select one, my pointer comes up in rotate mode so i can't pick and place the carving. Any ideas?
joe

[Scooby]

Click the Escape key

[bergerud]

You might want to make sure that the "Reset tool after use" is checked under the Edit - Preferences

[mtylerfl]

Also make sure you haven’t got the item “locked” to the Center of the board (both horizontally and vertically). If you do, then you cannot move the item - you can rotate it, but that’s all.

[Digitalwoodshop]

Also make sure you haven’t got the item “locked” to the Center of the board (both horizontally and vertically). If you do, then you cannot move the item - you can rotate it, but that’s all.

Bet that is the most correct answer... So easy to overlook this...