View Full Version : measure
bernie
06-24-2018, 10:57 AM
My machine will not measure the board and will allowed to carve anything does anyone know what cat look for and to fix it
bergerud
06-24-2018, 11:01 AM
You need to be more specific. Just what does the machine do?
bernie
06-24-2018, 11:07 AM
machine starts
measuring the lent of the
board and keeps going out of the
machine
bernie
06-24-2018, 11:11 AM
machine starts measur
ing the lent of the board and keeps going out of the
machine
bergerud
06-24-2018, 11:13 AM
I think that would be the rear roller switch. The machine waits for the rear roller to drop (switch to open) before it looks for the end of the board. If the roller switch does not switch, the board keeps moving. Lift the left side of the rear roller up and down. Listen for the click of the switch. A blast of compressed air may be needed to blow out the dust.
Digitalwoodshop
06-24-2018, 11:14 AM
IF you use a board that is TOO Thin then it runs right out of the machine.
If one of your rubber roller switches sticks then it lets the board run right out. Use Sensor data to check switches.
A dirty board sensor can do it too... but 99% of the time it is a board less than 3/4 inch thick like 1/2 inch that does it.
bernie
06-24-2018, 12:02 PM
IF you use a board that is TOO Thin then it runs right out of the machine.
If one of your rubber roller switches sticks then it lets the board run right out. Use Sensor data to check switches.
A dirty board sensor can do it too... but 99% of the time it is a board less than 3/4 inch thick like 1/2 inch that does it.
thank you it was a roller I fix it and up and running
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.