View Full Version : Dioed
john e kline
03-31-2007, 08:19 PM
While carving I found a plastic square "U" shaped black dioed on the board being carved. There appears to be two diodes installed. The machine seams to be working fine. Does anyone know what this is? Could this just be a piece that was left behind during manufacturing?
Jeff_Birt
03-31-2007, 08:21 PM
Sounds like the home sensor which is mounted to the Z-truck (see user manual for a good picture). This sensor is no longer used as of firmware 1.119, so no worries.
john e kline
03-31-2007, 08:38 PM
Thanks, JOHN
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.