PDA

View Full Version : how can I get the names on this pattern to carve in centerline


bamaman315
05-16-2018, 02:43 PM
85977 trying to figure out how to load carve the names without chunks being knocked out
bergerud
05-16-2018, 03:04 PM
Have you tried applying some draft to the text?
SteveNelson46
05-16-2018, 03:48 PM
I made some minor adjustments in the heights, depths, draft, bit resolution, and removed all of the merges. I think this will carve better.

You can convert the raster text to centerline but you will need the Conform Vectors add-on to control the depth.
fwharris
05-16-2018, 04:05 PM
If you want to carve the text as "centerline" you need to edit and change the carve mode to centerline and select the conform box.
bamaman315
05-16-2018, 06:26 PM
I tried the pattern and when I changed it to centerline the names went away , it also says I need a license to use the conform option . What program do I need for that?
fwharris
05-16-2018, 08:27 PM
I tried the pattern and when I changed it to centerline the names went away , it also says I need a license to use the conform option . What program do I need for that?

They went away because the centerline text was in/on a carve region. Centerline is designed to carve on the top surface of the board. With conform it allows you to place centerline or any other type of vector below the surface of the board. Conform is an add of feature.

http://store.carvewright.com/product.php?productid=21143&cat=252&page=1