View Full Version : DFX Import Problem
easybean
03-11-2018, 11:36 AM
I'm looking for a little help. I just purchased the DFX importer. I created a dfx file in Inkscape. I imported it and set the line autoconnect to the finest setting. It did not complete the shapes. I still have disconnected vectors. I attempt to connect these lines by dragging the toggle points... but the software will not let me do it. Anyone know what I am doing wrong?
DickB
03-11-2018, 11:42 AM
Can you post the dfx file?
easybean
03-11-2018, 12:09 PM
Sure. Thank You.85687
easybean
03-11-2018, 12:11 PM
From what I can find on the internet, Inkscape's DFX export converts some spline to polylines. I think that there are extensions that might help this. Still... I do not understand why I cannot grab nodes and connect them.
Mike
DianMayfield
03-11-2018, 01:02 PM
Sometimes, DXF files will come with 2 copies of the lines on top of each other. That's whats happening here. When I delete one "set" I am able to connect the two end points that go together. :) Happens in Corel sometimes.
Go to View/Toggle non-endpoints to see the ones that are an issue
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.