Changing angle of carved area

[Dale]

I use this MCP to make a storage area for pegs on the back of square and rectangle cribbage boards. I would now like to use it on a round cribbage board but need to change the angle. Is there a way to do this or do I have to design it again. This would be especially hard if I want it at an angle other than 90,180,270, or 360. For an example on the circular board I would like to place the storage area where the drill hole is.






8547185472

[fwharris]

You will probably need to redraw it for the round board since you can not rotate vectors. Not sure how it would work if you tried to convert your drawing to a pattern.

[Dale]

I already tried converting it to a pattern and it converted everything into just the 1/16" carving bit, which then leaves sloped edges which will not work.