Will this layout work going through the machine

[cjones]

I have a client who installs Gym floors. I have been able to start getting some of their leftover flooring pieces and am going to do a sign for them. I have staggered the boards on the ends, keeping the first one the full length of the project.

My question is, will this work OK going through the CW? I am going to center the logo in the middle of the longest board, the first one, so there will be more then 6"-8" on each end so as to stay under the rollers.

Thanks in advance for you assistance,

Chris Jones

[lynnfrwd]

No. Put in filler pieces and make it properly prepared material. Masking Tape may also be your friend.

[fwharris]

Place them on a sled/carrier board and add filler pieces or tape over the voided areas.

[RogerB]

Also remember you can only carve 1/4 inch deep before you hit your joint.Less if it is flooring from China.