View Full Version : How to apply outline pattern
jerrymorgan
11-05-2017, 11:24 AM
85026
How to apply outline pattern to my Lacrosse rack outline?
V/r Jerry Morgan
fwharris
11-05-2017, 12:46 PM
You do not have a pattern. It is a vector/line drawing. Just select your lines and then select the cut path tool.
jerrymorgan
11-05-2017, 01:10 PM
Okay, I will try it. thank you.
cestout
11-05-2017, 05:14 PM
Break the line in a few places to leave areas in cut so your pieces won't bounce around. Cut Path does not leave tabs.
Clint
mtylerfl
11-11-2017, 01:15 AM
Break the line in a few places to leave areas in cut so your pieces won't bounce around. Cut Path does not leave tabs.
Clint
Hi Clint,
I'm a bit confused on your statement above.
The Cut Path Tool DOES create tabs! (They are not visible on-screen, but they WILL be present on your actual board cutouts.)
I am guessing you are thinking of a situation where a Manual Bit Assignment is made to a vector? Whatever the thinking was, if the Cut Path Tool is used as normal, then tabs will be present A-OK.
cestout
11-11-2017, 01:18 PM
If you draw a line and say cut on this line, the machine will do just that. If the line is a closed loop of some kind, there will be nothing to hold the enclosed area in place. If you use the cutout tool the machine places tabs.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.