New USAF Box

[flyingemt]

All,

Thought I would share this image, took a while to merge imaging and get a good output! Prototype set for 24 x 32." Of course I will have to split it down the middle, but it can be done.

84977

[oscarl48]

Very cool. My local base wood shop does this on their 8 ft bed cnc machine for shadow boxes.

Is that what you will be using it for? They churn a lot of them out.

[Ducky63]

I'm looking for the Air Force emblem or Logo for a friend that has a grandson that is going into the air Force. They want me to make them a plaque with it on. Thank you!!!!

[oscarl48]

Ducky, Air Force logo previously shared by a generous member under insignias and military pattern sharing thread a while ago.

https://forum.carvewright.com/showthread.php?17358-Insignias-amp-Military

[Ducky63]

oscarl 48, Thank you for letting me know where to look. I think that I found what they like.

[shortyscwater17]

Hard to see in the picture, but are the stripes and the circle recessed a bit? If so, it would be awesome to add an additional pattern for some inlay pieces so you can offset the woods. I've made a few MSgt and CMSgt stripe shadow boxes and have done it, it looks amazing. However, I did all my by hand with a router, and the help of a laser engraver to mark lines.

85461

All,

Thought I would share this image, took a while to merge imaging and get a good output! Prototype set for 24 x 32." Of course I will have to split it down the middle, but it can be done.

84977