svduran
03-28-2007, 12:30 PM
Software suggestions:
4. Ability to change speeds inside part: Fine or slow for inside carving, faster for cutouts.
5. Display scale or ruler next to part: My old eyes are tired of counting squares. A scale could speed things up.
6. Cutout function should have: Inside, Outside, Center, Right, Left, Top, Bottom, selections. This would eleminate part fitting problems.
7. Auto test run inside program: After completion of drawing, I would like to see a simple pointer move over the part and highlight which segment it was cutting. This would help me speed up my part times by reducing the number of times the board is moved back and forth.
4. Ability to change speeds inside part: Fine or slow for inside carving, faster for cutouts.
5. Display scale or ruler next to part: My old eyes are tired of counting squares. A scale could speed things up.
6. Cutout function should have: Inside, Outside, Center, Right, Left, Top, Bottom, selections. This would eleminate part fitting problems.
7. Auto test run inside program: After completion of drawing, I would like to see a simple pointer move over the part and highlight which segment it was cutting. This would help me speed up my part times by reducing the number of times the board is moved back and forth.