View Full Version : My Carvewright struggles with Cut Path DXF cuts sometimes...Hardware?
dandjwoodenboards
07-28-2017, 11:17 PM
My Carvewright struggles with DXF cuts sometimes...it will start cutting inward with each pass (which creates a 45 degree angle) It's failing more and more on cut paths. As it cuts, it cuts in closer than I designed it to with each pass. I am inclined to think that it's a hardware issue. I use pine for almost everything I cut. I have been noticing that that the axis that crosses the board (Left and right) is getting jumpy. This is an issue for me as it costs me material.
bergerud
07-29-2017, 12:50 AM
Show some pictures. Are you talking about X tracking issues and stair stepping?
fwharris
07-29-2017, 01:17 AM
How many carving (cut motor) hours do you have? It could be bad/dirty bearing on the Y truck or in the Y gear box.
cestout
07-30-2017, 01:59 PM
Is it just on DXF vector carves? Try the attached test carve.
Clint
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.