PDA

View Full Version : Machine Bolt pattern ?



Ropdoc
01-16-2017, 05:27 AM
Hello All,

I am working on a table for my machine. It is going to be a simple one. I do not have the machine right now but I need to know the bolt pattern dimensions for the machine. The bolt holes the hold the machine to a table.

Thank you

bergerud
01-16-2017, 10:29 AM
The table top would need to be around 17" by 23" for the base to fit on it. The bolt holes are around 15.2" and 18.2" (I would wait for the machine to actually drill the holes.) Anyone else confirm?

SteveNelson46
01-16-2017, 11:34 AM
I made this cabinet before there were any dust collection systems so there is a dead space at the top for the downdraft system with a 4" DC adapter on the back side. The top is 28" by 40" and the holes for the mounting bolts were marked after the cabinet was made and are pretty close to Bergerud's measurements

myshop1044
01-17-2017, 11:13 AM
This my machine stand, they works very well, lot of storage under the table,
I bought a stand, placed a top on it cut a slot in the top. no need to bolt it down.
with that much weight , it is not going anywhere. The nice part is I can roll it anywhere.