sundog2001
03-24-2007, 04:59 PM
I am having a problem with the CC measuring the board length correctly just before carving the project.
I can use the measure length (option 7) to measure the board correctly, but once I enter a project, it measures the length shorter than it is.
I am trying to carve some light colored cedar. I tried a strip of masking tape on the ends which didn't help. I blackened an area on the masking tape with a felt tip and got a clear sensor message, so I know it is sensing the end of the board.
I searched "measuring board" on this forum, but didn't find any posts addressing this specific problem.
Any suggestions?
Otherwise, my CC has been carving better than ever since I replaced the bit holder, keypad ribbon and glued the z-truck ribbon securely.
Thanks.
Art
I can use the measure length (option 7) to measure the board correctly, but once I enter a project, it measures the length shorter than it is.
I am trying to carve some light colored cedar. I tried a strip of masking tape on the ends which didn't help. I blackened an area on the masking tape with a felt tip and got a clear sensor message, so I know it is sensing the end of the board.
I searched "measuring board" on this forum, but didn't find any posts addressing this specific problem.
Any suggestions?
Otherwise, my CC has been carving better than ever since I replaced the bit holder, keypad ribbon and glued the z-truck ribbon securely.
Thanks.
Art