myshop1044
12-11-2016, 09:56 AM
attached is a sketch , what I am looking for is a tree, no leaves, and a limb running left to right. I have never been able to create a pattern from a dwg. this tree may be placed in the middle of a region or placed in the bottom left corner using "clip". the rest of the dwg is not going to used, I hope.
any help with this would be great, it does dot have to have great detail just a good looking tree. the limb does not have to be full as shown, it can be smaller and part of the tree cab be shown below the limb, I am will to talk money if needed. so if you can create a ptn from this let your mind run with it.
thank ahead of time
Perry B.
any help with this would be great, it does dot have to have great detail just a good looking tree. the limb does not have to be full as shown, it can be smaller and part of the tree cab be shown below the limb, I am will to talk money if needed. so if you can create a ptn from this let your mind run with it.
thank ahead of time
Perry B.