Drilling holes.

[papawbummie]

Can i draw a line and drill holes spaced across the line equally spaced like a cribbage board line or curvy Thanks Bert

[fwharris]

Yes you can. It is best that you use "snap to grid" to get evenly spaced holes.

[Mugsowner]

I have made a few cribbage boards and yes you can. Put the lines where you want the the holes to follow and start putting holes where you need them on the lines. Delete lines and your good to go.

[bergerud]

Can i draw a line and drill holes spaced across the line equally spaced like a cribbage board line or curvy Thanks Bert


It can be a little tricky on curves or slanted lines if the holes do not line up with the snap grid. Maybe you could post an example of what you are thinking of doing.

[DickB]

With Designer 3 you can use the Pattern Along Trajectory tool to place evenly-spaced patterns along a line. I used a simple circular pattern here as a guide. To drill holes I would place the drill bit in the center of each of the circles, then delete the pattern. But as bergerud said, it would be helpful to know more details about your project.

82373 82374