Project across boards

[DianMayfield]

I am pretty sure I have split a project across multiple boards before, but I cannot figure out why the "finish' button is grayed out. Any ideas on the step I missed?? I have saved it.

[bergerud]

I have not tried to split a DXF across boards before, but , it seems to me that each spline object must be on its own board. Trying to have the importer break the curves may be expecting too much.

[DianMayfield]

That certainly makes sense. I will try one board and shifting. Thanks!

[fwharris]

This might help you out.. http://www.carvewright.com/up-cycle-an-old-cedar-fence/

[DianMayfield]

:) I just went looking for the conference info, I knew that Joe had done the fence there. Eureka! pesky split across boards button on the "shapes" tab!

[bergerud]

Cool. I love to find out new things. I did not know about that one.