PDA

View Full Version : Project across boards



DianMayfield
10-01-2016, 01:03 PM
I am pretty sure I have split a project across multiple boards before, but I cannot figure out why the "finish' button is grayed out. Any ideas on the step I missed?? I have saved it.

bergerud
10-01-2016, 04:12 PM
I have not tried to split a DXF across boards before, but , it seems to me that each spline object must be on its own board. Trying to have the importer break the curves may be expecting too much.

DianMayfield
10-01-2016, 04:17 PM
That certainly makes sense. I will try one board and shifting. Thanks!

fwharris
10-01-2016, 04:25 PM
This might help you out.. http://www.carvewright.com/up-cycle-an-old-cedar-fence/

DianMayfield
10-01-2016, 04:54 PM
:) I just went looking for the conference info, I knew that Joe had done the fence there. Eureka! pesky split across boards button on the "shapes" tab!

bergerud
10-01-2016, 05:00 PM
Cool. I love to find out new things. I did not know about that one.