PDA

View Full Version : 3 views of cross



rcdages
09-19-2016, 11:45 AM
The three photos are of CarveBuddy ptn
It is 5 x 7 and carved in 0.75 select pine at a depth 0.625 height 999

They are just off the CW no sanding yet. Great detain in dept. I feel
more over all detail.

Carved with the 1/32 bit. Off course knowing me. Carving time 01:06;45 carved on
the Optimal setting.

I will post again as I move in to my finishing of the cross.

818998189881900

DonCP
09-19-2016, 11:56 AM
Did not know CarveBuddy had this pattern.
Can you show me where it is at? Been using the pattern from the forum

Been carving 9x12 on best with 1/16 bit on .75 select pine.
That is 2 hr 15 min carve time. Optimum is 3 hrs 15 min. too long I think.

Your depth looks better, which if smaller makes sense.

My family and friends are driving me nuts with requests for this.

Ya know, that is a good thing :)

bergerud
09-19-2016, 12:06 PM
I do not think the cross pattern is from CarveBuddy. Here is the original thread where it was scanned by Woodknack in 2007.

http://forum.carvewright.com/showthread.php?5140-jesus-cross&p=36037#post36037

rcdages
09-19-2016, 12:15 PM
Don,

Go to CarveBuddy web site.

bergerud
09-19-2016, 12:17 PM
I see it is on the CarveBuddy website for $1.00.

rcdages
09-19-2016, 12:17 PM
bergerud

The one your talking about is the one I have been using.

Now switching over to CB's

rcdages
09-19-2016, 12:26 PM
Quite the value for a buck !!!!!!!!!!!!!!!!!

DonCP
09-19-2016, 06:26 PM
Yep! This pattern looks like it's cleaned up quite a bit.
Also lets me play with 3 formats very inexpensively.
Thank you both.