View Full Version : Need simple column
gbrlbll
05-29-2016, 01:08 PM
Hello carvers!
Need some help finding a pattern for a simple column. Just a smooth even column no flutes or tapers. I want to carve them into the left and right stiles of a corner cabinet, .75 stock 2"wide column 27" tall. I cannot figure out how to do this in my designer and have been unable to locate a pattern to purchase. Any help would be appreciated!
Thanks,
-G
oscarl48
05-29-2016, 03:26 PM
Here is a quick plain column that is .75"x2"x27". See if it helps or if it needs to be modified.
O
SteveNelson46
05-29-2016, 06:57 PM
There is one in the Pattern Depot for $5.00
http://store.carvewright.com/product.php?productid=17731&cat=&page=1
gbrlbll
05-30-2016, 10:48 AM
There is one in the Pattern Depot for $5.00
http://store.carvewright.com/product.php?productid=17731&cat=&page=1
Wasnt exactly what I was looking for, but thank you!
cestout
06-01-2016, 05:57 PM
All you really need to do is create a rectangular carved out area about .05 deep any size, and dome it with the horizontal dome then set the height to 999. Make it a group and select the group to make it a pattern. Place the pattern on a board and stretch it to any size you want. That is good in 1.187 with no add-ons.
Clint
farmer
06-05-2016, 07:15 PM
Here is one I made in Blender.
henry1
06-05-2016, 07:41 PM
Here is one I made in Blender.
to bad its not in 187 or 2 when you made it dam
SteveNelson46
06-05-2016, 09:34 PM
Will this help? I did it in Aspire but it can be done in the Designer using the Rail Sweep tool. Michael Tyler has a great video on the add-ons webpage.
http://www.carvewright.com/add-on-modules/pattern-modeling/
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.