mtylerfl
05-06-2016, 01:15 PM
Hello,
Hers and His Eyeglass Holders in the “Schnoz” style. The “man” holder features a thick mustache and the “woman” holder features lush, full lips under their “schnozes”! Place your schnoz eyeglass holders on a bedside table or anywhere handy. You won’t have to hunt for your glasses ever again!
The project uses just the 1/16" Carving Bit and the 1/8" Cutting Bit. No other bits are required. The finished dimensions are about: 4.5" wide x 3.5" deep x 6.5" tall.
Main items you will need:
1) The Project Files (included):
• Glasses_Nose_Holder.mpc
• Base-and-Back.mpc
2) Boards with the following dimensions:
Glasses Nose Holder: 0.75" x 11" x 21"
Base and Back: 0.75" x 9" x 16"
NOTE: Do not use boards that are smaller than specified above unless using an appropriate jig. Larger boards are fine.
3) Two 0.25" x 3.75" wood dowels
4) Sandpaper, wood glue, epoxy, wood stain and/or paint and clear finish
5) A Dremel-type rotary tool with assorted sanding wheels and bits to sand small details and speed up preparation for finishing.
Apply your choice of finish. Here’s what I used on my Schnoz Eyeglass Holder samples made from Select Pine:
BASE:
• Applied Rust-Oleum Traditional Cherry stain
• Several coats of gloss Krylon Clear Acrylic spray
NOSES:
• Two coats of full-strength SealCoat
• Several coats of gloss Krylon Clear Acrylic spray
Hers and His Eyeglass Holders in the “Schnoz” style. The “man” holder features a thick mustache and the “woman” holder features lush, full lips under their “schnozes”! Place your schnoz eyeglass holders on a bedside table or anywhere handy. You won’t have to hunt for your glasses ever again!
The project uses just the 1/16" Carving Bit and the 1/8" Cutting Bit. No other bits are required. The finished dimensions are about: 4.5" wide x 3.5" deep x 6.5" tall.
Main items you will need:
1) The Project Files (included):
• Glasses_Nose_Holder.mpc
• Base-and-Back.mpc
2) Boards with the following dimensions:
Glasses Nose Holder: 0.75" x 11" x 21"
Base and Back: 0.75" x 9" x 16"
NOTE: Do not use boards that are smaller than specified above unless using an appropriate jig. Larger boards are fine.
3) Two 0.25" x 3.75" wood dowels
4) Sandpaper, wood glue, epoxy, wood stain and/or paint and clear finish
5) A Dremel-type rotary tool with assorted sanding wheels and bits to sand small details and speed up preparation for finishing.
Apply your choice of finish. Here’s what I used on my Schnoz Eyeglass Holder samples made from Select Pine:
BASE:
• Applied Rust-Oleum Traditional Cherry stain
• Several coats of gloss Krylon Clear Acrylic spray
NOSES:
• Two coats of full-strength SealCoat
• Several coats of gloss Krylon Clear Acrylic spray