incorrect reading of load data from 2 different flash cards

[myshop1044]

I down loaded 3 different projects, same POM, the project on each board is 18 x 11 x .75.
the machine reads 44.45 x 20.32 x 1.905 on each project. I reloaded the 3 projects on a new flash
card and had the same readings.
I checked different projects that was already on the new flash card and all were wrong dem.s.
I went to the second machine and everything with perfect, so it is the first machine. where do I go to correct this problem,
I also unplugged the machine hoping it would clear, no such luck.
Help.
Perry

[bergerud]

The numbers do not quite all convert right, but, maybe metric?

[mtylerfl]

That is puzzling. The 0.75" (Z) converts to centimeters as 1.905, so that matches. But...the X and Y inch dimensions don't convert accurately to the metric values you see, as Berg says.

In any case, make sure your machine Measurement Setting is in Std mode not metric. (the measurement setting is in the User Options menu on your machine in case you didn't know)

[myshop1044]

You have lost me now.

[myshop1044]

when back and checked the standard and it was set to metric. you are the man, thanks again.
Now all we have to worry about the flood level in the basin, my brother in law's camp is about a ft.
out of the water and it normally sits about 30 ft. out of the water on a hill.
Perry B.

[myshop1044]

Yes, I rechecked the projects after I set the standard back and each one is back to narmal.

[Digitalwoodshop]

Glad you got it fixed.... GOOD JOB !!!

AL