PDA

View Full Version : 3/4" board might be too thin?



myshop1044
12-31-2015, 09:31 AM
Never seen this one before during cut path bit check, it touch board then check the depth on the plate
then check the depth on the board (3/4"), stopped a gave the error message
"Board may be too thin 1.86/1.91, abort or cont.
I hit cont. to let it carve first, by the time it gets to the cutpath 2 1/2 hrs, I ill be watching very closely.
any ideas.
Perry B.

bergerud
12-31-2015, 10:01 AM
I would say your board thickness calibration is slightly off. Watch closely, you may get thick tabs and/or it may not cut all the way through. I think it will adjust the cut depth according to the 1.86.

I would do a thickness calibration.

myshop1044
12-31-2015, 10:31 AM
How is that done?

bergerud
12-31-2015, 10:36 AM
See: http://www.carvewright.com/assets/service/Maintenence/Carvewright_User_Calibration.pdf

myshop1044
12-31-2015, 11:47 AM
Just finish my carve and had no problems, even though I said to continue to the error message, I went and recal. the depth as per you pdf.
see attached.
Thanks very much and have a Happy New year 2016
Perry B.

henry1
12-31-2015, 12:08 PM
Just finish my carve and had no problems, even though I said to continue to the error message, I went and recal. the depth as per you pdf.
see attached.
Thanks very much and have a Happy New year 2016
Perry B.
What are you running windows 7 for the carving, why I ask I am having problem with windows 10 it will not programmed the card

myshop1044
12-31-2015, 12:21 PM
No windows 7 or 10, wan't get near them.

myshop1044
12-31-2015, 12:29 PM
my bad, windows 7 home premium

henry1
12-31-2015, 12:40 PM
my bad, windows 7 home premium

I thought so connie is saying most of us is on 10 I can't see that thx for the reply

Canemaker
12-31-2015, 05:28 PM
Ok Perry, you have us all confused. What is it?

myshop1044
12-31-2015, 06:50 PM
Confused about what, It is clear as mud on New Year's Eve night.
I Just ate a dozon oysters, crab meat augraton, 2 margies, and there is no more problems tonight.

Mugsowner
12-31-2015, 06:56 PM
Canemaker it is a onesie. Check out this post Looking for a patern or web site to buy one (http://forum.carvewright.com/showthread.php?28233-Looking-for-a-patern-or-web-site-to-buy-one)

myshop1044
12-31-2015, 07:00 PM
Yes the picture is the back side of my onesie and the tabs worked just fine