View Full Version : PTN Help
xchief807
10-09-2015, 04:24 PM
Any help with this PTN would be great I need it for a baby gift. I made a blanket chest/ Toy chest and want to put this on the lid. There are 2 pictures either one is fine.
Thanks
7822478225
bergerud
10-09-2015, 04:32 PM
You might try and find an image with higher resolution. I will give this a go when I get home from work.
zan29
10-09-2015, 04:37 PM
You will have to optimize and use a small draft. Hope it works for you.
Suzanne
xchief807
10-09-2015, 05:52 PM
Here is one with a higher resolution
78232
xchief807
10-09-2015, 05:53 PM
Suzanne do you mean to optimize the bit?
zan29
10-09-2015, 06:08 PM
yes Kevin!
Suzanne do you mean to optimize the bit?
SteveNelson46
10-09-2015, 07:20 PM
Try to import this one. You may need to clean it up in the Pattern Editor.
bergerud
10-09-2015, 09:41 PM
Here is an attempt with xchief's post.
henry1
10-10-2015, 02:20 AM
Any help with this PTN would be great I need it for a baby gift. I made a blanket chest/ Toy chest and want to put this on the lid. There are 2 pictures either one is fine.
Thanks
7822478225
Will this do
xchief807
10-10-2015, 07:41 AM
All great PTN's thank you everyone.
jpaluck
10-10-2015, 04:32 PM
Here is one from a 3d model I made way and used blender bas relief to make 2.5d. I couldn't find the actual model but here if depth map...remove background and sculpt the steeping smooth and your good
RogerB
10-10-2015, 05:48 PM
Nice to see so much help.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.