PDA

View Full Version : Y axis stall



mijoda52
09-03-2015, 07:07 PM
Hello everybody. I have a machine that has 25 hours on it that is about 3 1/2 years old. I am getting y-axis stalls and then the control panel goes blank. I can tap on the edge of the control panel and the panel comes back on. Sometimes it stays on sometime it goes right back off. My initial theory was either a switch problem or a control panel problem. I by-passed the switch and it made no difference. I installed a new control panel but still have the stall problem. I cannot make the control panel go blank by tapping on it but I can bring it back to life by tapping. I removed the bottom panel and checked all of the connections and reseated the ones that were not glued together. I recently installed the latest version of the software and am beginning to wonder if that could be causing my problem. Anybody have any theories. Thanks.